Bentley Mobile RV Repair
- Winterize & De-Winterize
- Insurance Work
- RV Inspections
- Preventative Maintenance
- Exterior Sealing
- Accessory Installation
- Appliance Repairs
- LPG (Propane) System/Appliances
- Plumbing/Water Systems
- Walk Through/Orientation
- Cabinet Repair
- Electrical Repairs
- Emergency House, Electrical, Appliance, Slide Out Repairs
- Floor, Wall & Structure Repairs
- Leveling Systems
- Other
- RV Windows
- Slide, Topper & Awning Installation
- Warranty Work
- Washing
- Airstream Service
- Big Rig RV Repair
- General Maintenance
- Food Trucks and Trailers
Message this Provider Now
Write a Review
Share this Provider
Latest Questions by the RV Community
Cost to repair hydrulic leak
Leveler system hydraulic system blew out fluid
Trailer Brake System Error Message
Experiencing an issue with the trailer brake system. The front axle on my dual axle camper trailer stopped turning while pulling into a campsite, dragging and creating a rut in the grass. Received an error message about servicing the trailer brake system. After stopping, I unplugged the 7-way connector and reinserted it, allowing the trailer to roll again, but the error message remains. I cleaned both the plug and socket with an emery board and CRC contact cleaner. Still receiving the message when plugged in.
Troubleshooting Suburban SW6DE Water Heater AC Mode
The SW6DE water heater provides electric and propane heating. The propane side works, and the AC side has been tested for a stuck toggle switch, continuity, and resistance with no issues found. The heating element also shows continuity. The AC side does not produce hot water after 2 hours of operation. What steps should be taken next to diagnose the AC heating issue?
Sikaflex 715 Leveling Concerns After Skylight Repair
I replaced the outer skylight shell on my Winnebago Vista and used Sikaflex 715 for sealing. It has good adhesion but is not leveling as expected after 2 days. I am concerned about water drainage from the skylight. What are your thoughts on improving leveling, and should I consider scraping it off and starting over?