Greg got the correct Ac unit to connect to existing Thermostat and overall system Otherwise I would have had to spend a lot more money getting more parts Install was pretty quick and now new AC is installed and works great. He checked to verify proper temp variance verifying it was irking correctly He also while on the roof located some small holes with all my seals around skylights and vents He applied proper sealant/caulk to all existing holes at no extra charge He did a good job and is highly recommended
- RV Inspections
- Preventative Maintenance
- Exterior Sealing
- Generator Maintenance
- Appliance Repairs
- Plumbing/Water Systems
- Walk Through/Orientation
- Cabinet Repair
- Electrical Repairs
- Leveling Systems
- Other
- Roof Maintenance
- Slide, Topper & Awning Installation
- Warranty Work
- General Maintenance
Message this Provider Now
Write a Review
Share this Provider
Latest Questions by the RV Community
Trailer Brake System Error Message
Experiencing an issue with the trailer brake system. The front axle on my dual axle camper trailer stopped turning while pulling into a campsite, dragging and creating a rut in the grass. Received an error message about servicing the trailer brake system. After stopping, I unplugged the 7-way connector and reinserted it, allowing the trailer to roll again, but the error message remains. I cleaned both the plug and socket with an emery board and CRC contact cleaner. Still receiving the message when plugged in.
Diagnosing a Bad Inverter in RV
Half of the outlets are not powered, and the green light on the affected inverter is not lit. The Vegatouch indicates that inverter number two is not powered or charging. Shore power is connected and both lines are confirmed to be outputting 120V. The breaker/thermal on the Magna Inverter chassis is not popped. Questions include whether AC flow works if the inverter/charger is faulty, if the AC power doesn’t flow through during an internal failure of the Magna, how to test if the inverter is faulty, and whether there are GFCIs in the rig.
Difficulty Removing Pivot Bolts on HWH Jack
I am removing the HWH kick-down jack for repairs and need help with the pivot bolts. They are 1-5/15 hex head, 7/8" diameter bolts. I have applied penetrating oil but they are not budging. Has anyone had this issue removing the pivot bolts? What is the installation torque for these bolts?
Suggestions for Portable Auxiliary A/C Units
Looking for suggestions for a portable A/C unit to supplement the dash A/C in an RV during a 7,000 mile trip.
Replacement front bunk
Can you fix front pop out on my 2015 roo rockwood and if so how soon