The Vansmith
Message this Provider Now
Write a Review
Share this Provider
Claim Provider
Latest Questions by the RV Community
Installing Onan 4.0 RV Generator in 1996 Newmar Kounty Aire
I have a 1996 Newmar Kounty Aire 5th Wheel and want to install an Onan 4.0 RV GenSet. Is an outer case necessary for installation, or is it mainly for sound and heat protection? Also, the ID tag is worn and I'm unable to read the specs. Can anyone provide information or direct me to a manual or specifications?
Trailer Brake System Error Message
Experiencing an issue with the trailer brake system. The front axle on my dual axle camper trailer stopped turning while pulling into a campsite, dragging and creating a rut in the grass. Received an error message about servicing the trailer brake system. After stopping, I unplugged the 7-way connector and reinserted it, allowing the trailer to roll again, but the error message remains. I cleaned both the plug and socket with an emery board and CRC contact cleaner. Still receiving the message when plugged in.
Diagnosing a Bad Inverter in RV
Half of the outlets are not powered, and the green light on the affected inverter is not lit. The Vegatouch indicates that inverter number two is not powered or charging. Shore power is connected and both lines are confirmed to be outputting 120V. The breaker/thermal on the Magna Inverter chassis is not popped. Questions include whether AC flow works if the inverter/charger is faulty, if the AC power doesn’t flow through during an internal failure of the Magna, how to test if the inverter is faulty, and whether there are GFCIs in the rig.
Has anyone Installed the RV5 solor ELECTRICAL SYSTEM
Need a RV Electrician to install my bluetti RV5 solor ELECTRICAL SYSTEM and #2=700watt panels
Leveling Jack Beeping Issue on Holiday Rambler Endeavor
A 2004 Holiday Rambler Endeavor produces a loud beeping noise when the parking brake is released and the RV is in gear. The beeping stops when in neutral. All jacks are fully retracted. Automatic transmission fluid was added according to the manual, but the beeping continues. What else can be checked?