
We had started a camping trip with our trailer and our truck suffered a major engine failure mid trip and I had to buy a new one. The new truck sat a little lower than my old one so I was in a bit of a fix with my trailer hitch which can be set at different heights but i didn’t know how to do it properly. One call to Terry was all it took. He came to my campsite the morning of check out and had me ready to go and we were out even an hour early. The trailer towed like a dream. Terry is professional, personable and charged reasonable prices for his work. I would recommend him any day and twice on Sundays.
Having trouble getting the lights to work with the plug-in cord for a 26 GMC 2500 Denali set up for flat towing. A company installed Blue Ox baseplates and an Air Force One braking system, but the wiring is not functioning correctly. They tried a Curt plug-and-play kit and a Blue Ox diode kit, but the lights still do not work. Seeking advice on resolving this issue.
Experiencing an issue with the trailer brake system. The front axle on my dual axle camper trailer stopped turning while pulling into a campsite, dragging and creating a rut in the grass. Received an error message about servicing the trailer brake system. After stopping, I unplugged the 7-way connector and reinserted it, allowing the trailer to roll again, but the error message remains. I cleaned both the plug and socket with an emery board and CRC contact cleaner. Still receiving the message when plugged in.
The SW6DE water heater provides electric and propane heating. The propane side works, and the AC side has been tested for a stuck toggle switch, continuity, and resistance with no issues found. The heating element also shows continuity. The AC side does not produce hot water after 2 hours of operation. What steps should be taken next to diagnose the AC heating issue?
How long can RV tires remain mounted if driven only about 200 miles per year, protected from the sun and showing no signs of dry rot?
I replaced the outer skylight shell on my Winnebago Vista and used Sikaflex 715 for sealing. It has good adhesion but is not leveling as expected after 2 days. I am concerned about water drainage from the skylight. What are your thoughts on improving leveling, and should I consider scraping it off and starting over?