Georgia Truck & Tire Repair Services

Nearby
In Shop Only
Orange Logo
Recent Reviews
Service Areas
Map showing undefined service area
Servicing area
301 Dungeness Drive
Brunswick, GA, 31523
Active
Services
No services listed

Orange Logo Message this Provider Now

Message this provider for service requests and support.

Write a Review

Do you have experience with this provider? Share your thoughts and help others find the best service.

Share this Provider

Help others find this provider by sharing their profile.

Claim Provider

Latest Questions by the RV Community

REPLACE/REPAIR GLASS IN REAR SLIDEOUT WINDOW

I am having a hard time finding replacement glass for the rear slide out sliding window. It is double-paned, measuring approximately 25"H x 48" L.

Eric4 months ago132 views1 answers
0

Cost to repair hydrulic leak

Leveler system hydraulic system blew out fluid

Alton D Grisham3 months ago136 views2 answers
0

Dometic Penguin 2 Fan Motor Not Starting

The front Dometic Penguin 2 fan motor does not start on its own. The motor, starter capacitor, relay, and run capacitor have been replaced. The fan operates when manually assisted.

Edward Coleman2 months ago106 views9 answers
0

Leveling Jack Beeping Issue on Holiday Rambler Endeavor

A 2004 Holiday Rambler Endeavor produces a loud beeping noise when the parking brake is released and the RV is in gear. The beeping stops when in neutral. All jacks are fully retracted. Automatic transmission fluid was added according to the manual, but the beeping continues. What else can be checked?

David Thompson1 month ago148 views4 answers
-1

Trailer Brake System Error Message

Experiencing an issue with the trailer brake system. The front axle on my dual axle camper trailer stopped turning while pulling into a campsite, dragging and creating a rut in the grass. Received an error message about servicing the trailer brake system. After stopping, I unplugged the 7-way connector and reinserted it, allowing the trailer to roll again, but the error message remains. I cleaned both the plug and socket with an emery board and CRC contact cleaner. Still receiving the message when plugged in.

Albert Griffin3 months ago119 views5 answers
0