Sikes RV Repair

Sikes RV Repair

Nearby
Orange Logo
Recent Reviews
Service Areas
Map showing undefined service area
Servicing area
607 East County Road 7250
Lubbock, TX, 79404
Travel up to 9.9 mi from Lubbock, TX, 79404
Active
Services
No services listed

Orange Logo Message this Provider Now

Message this provider for service requests and support.

Write a Review

Do you have experience with this provider? Share your thoughts and help others find the best service.

Share this Provider

Help others find this provider by sharing their profile.

Claim Provider

Latest Questions by the RV Community

Sikaflex 715 Leveling Concerns After Skylight Repair

I replaced the outer skylight shell on my Winnebago Vista and used Sikaflex 715 for sealing. It has good adhesion but is not leveling as expected after 2 days. I am concerned about water drainage from the skylight. What are your thoughts on improving leveling, and should I consider scraping it off and starting over?

Karen Torres3 months ago229 views3 answers
0

Has anyone Installed the RV5 solor ELECTRICAL SYSTEM

Need a RV Electrician to install my bluetti RV5 solor ELECTRICAL SYSTEM and #2=700watt panels

George walker2 months ago110 views1 answers
-1

Dometic Penguin 2 Fan Motor Not Starting

The front Dometic Penguin 2 fan motor does not start on its own. The motor, starter capacitor, relay, and run capacitor have been replaced. The fan operates when manually assisted.

Edward Coleman2 months ago106 views9 answers
0

Air conditioner unit

I need a new air conditioner unit for my camper and don't know what i need. Please help

Paula Edge4 months ago183 views2 answers
0

Trailer Brake System Error Message

Experiencing an issue with the trailer brake system. The front axle on my dual axle camper trailer stopped turning while pulling into a campsite, dragging and creating a rut in the grass. Received an error message about servicing the trailer brake system. After stopping, I unplugged the 7-way connector and reinserted it, allowing the trailer to roll again, but the error message remains. I cleaned both the plug and socket with an emery board and CRC contact cleaner. Still receiving the message when plugged in.

Albert Griffin3 months ago119 views5 answers
0