We provide mobile housing for displaced homeowners throughout the United States. We utilize local vendors and contractors for various services. We found Mels Mobile RV service to be professional, friendly, responsive and cost effective. They are our preferred provider in their service area.
I reached out to Mel’s Via her website. Unfortunately, after two full business days she did not even acknowledge receipt of the work request. As a result, I sent a quick email canceling. She found time to respond after I canceled. In brief she said she was busy and was “sorry “ that I felt I should receive a response.
- Winterize & De-Winterize
- Preventative Maintenance
- Exterior Sealing
- Accessory Installation
- Appliance Repairs
- Detailing
- Plumbing/Water Systems
- Walk Through/Orientation
- Electrical Repairs
- Emergency House, Electrical, Appliance, Slide Out Repairs
- Roof Maintenance
- Roof Treatment
- Slide, Topper & Awning Installation
- Warranty Work
- General Maintenance
Message this Provider Now
Write a Review
Share this Provider
Claim Provider
Latest Questions by the RV Community
Troubleshooting Suburban SW6DE Water Heater AC Mode
The SW6DE water heater provides electric and propane heating. The propane side works, and the AC side has been tested for a stuck toggle switch, continuity, and resistance with no issues found. The heating element also shows continuity. The AC side does not produce hot water after 2 hours of operation. What steps should be taken next to diagnose the AC heating issue?
Air conditioner unit
I need a new air conditioner unit for my camper and don't know what i need. Please help
Sikaflex 715 Leveling Concerns After Skylight Repair
I replaced the outer skylight shell on my Winnebago Vista and used Sikaflex 715 for sealing. It has good adhesion but is not leveling as expected after 2 days. I am concerned about water drainage from the skylight. What are your thoughts on improving leveling, and should I consider scraping it off and starting over?
Difficulty Removing Pivot Bolts on HWH Jack
I am removing the HWH kick-down jack for repairs and need help with the pivot bolts. They are 1-5/15 hex head, 7/8" diameter bolts. I have applied penetrating oil but they are not budging. Has anyone had this issue removing the pivot bolts? What is the installation torque for these bolts?