Experiencing an issue with the trailer brake system. The front axle on my dual axle camper trailer stopped turning while pulling into a campsite, dragging and creating a rut in the grass. Received an error message about servicing the trailer brake system. After stopping, I unplugged the 7-way connector and reinserted it, allowing the trailer to roll again, but the error message remains. I cleaned both the plug and socket with an emery board and CRC contact cleaner. Still receiving the message when plugged in.
I replaced the outer skylight shell on my Winnebago Vista and used Sikaflex 715 for sealing. It has good adhesion but is not leveling as expected after 2 days. I am concerned about water drainage from the skylight. What are your thoughts on improving leveling, and should I consider scraping it off and starting over?
Looking for suggestions for a portable A/C unit to supplement the dash A/C in an RV during a 7,000 mile trip.
The SW6DE water heater provides electric and propane heating. The propane side works, and the AC side has been tested for a stuck toggle switch, continuity, and resistance with no issues found. The heating element also shows continuity. The AC side does not produce hot water after 2 hours of operation. What steps should be taken next to diagnose the AC heating issue?
I am removing the HWH kick-down jack for repairs and need help with the pivot bolts. They are 1-5/15 hex head, 7/8" diameter bolts. I have applied penetrating oil but they are not budging. Has anyone had this issue removing the pivot bolts? What is the installation torque for these bolts?