RV Glass Repair Services
Message this Provider Now
Write a Review
Share this Provider
Latest Questions by the RV Community
REPLACE/REPAIR GLASS IN REAR SLIDEOUT WINDOW
I am having a hard time finding replacement glass for the rear slide out sliding window. It is double-paned, measuring approximately 25"H x 48" L.
Sikaflex 715 Leveling Concerns After Skylight Repair
I replaced the outer skylight shell on my Winnebago Vista and used Sikaflex 715 for sealing. It has good adhesion but is not leveling as expected after 2 days. I am concerned about water drainage from the skylight. What are your thoughts on improving leveling, and should I consider scraping it off and starting over?
Diagnosing a Bad Inverter in RV
Half of the outlets are not powered, and the green light on the affected inverter is not lit. The Vegatouch indicates that inverter number two is not powered or charging. Shore power is connected and both lines are confirmed to be outputting 120V. The breaker/thermal on the Magna Inverter chassis is not popped. Questions include whether AC flow works if the inverter/charger is faulty, if the AC power doesn’t flow through during an internal failure of the Magna, how to test if the inverter is faulty, and whether there are GFCIs in the rig.
Leveling Jack Beeping Issue on Holiday Rambler Endeavor
A 2004 Holiday Rambler Endeavor produces a loud beeping noise when the parking brake is released and the RV is in gear. The beeping stops when in neutral. All jacks are fully retracted. Automatic transmission fluid was added according to the manual, but the beeping continues. What else can be checked?
Trailer Brake System Error Message
Experiencing an issue with the trailer brake system. The front axle on my dual axle camper trailer stopped turning while pulling into a campsite, dragging and creating a rut in the grass. Received an error message about servicing the trailer brake system. After stopping, I unplugged the 7-way connector and reinserted it, allowing the trailer to roll again, but the error message remains. I cleaned both the plug and socket with an emery board and CRC contact cleaner. Still receiving the message when plugged in.